






2013-2015 Ford Escape ABS Anti Lock Brake Pump Module CV61-2C405-AG OEM
CV61-2C405-AG
VIN programming required after install
This module needs VIN programming after install. A dealer or locksmith with the right scan tool can do it. Not sure your installer can program? Message us first — we'll help you confirm.
Tested and functional. Connector pins intact. Cleaned exterior.
This is the front ABS Anti-Lock Brake Pump Module for the 2013–2015 Ford Escape, carrying OEM number CV61-2C405-AG. On these vehicles, ABS module faults commonly trigger the ABS warning light and may disable traction or stability control. This unit has been tested and confirmed functional, with intact connector pins and a cleaned exterior. Important: on vehicles where this module requires programming, the dealer scan-tool procedure normally reads the existing configuration from your original module — so leave the original fitted until the replacement has been programmed if you can. If it has already been removed, the procedure can still be completed by entering the As-Built data.
From the shop
Brake pressure at each corner is only as good as the module coordinating it, comparing what the wheel-speed sensors report and adjusting the hydraulic unit so no single wheel grabs and locks under braking. On these, a failure usually shows up as the ABS light staying lit while the anti-lock function goes quiet, meaning you still get normal stopping power just without the wheel-by-wheel correction. Tested and functional. Connector pins intact. Cleaned exterior. Mounts front. This unit requires programming to your vehicle after installation. Fits 2013–2015 Ford Escape. Part numbers: CV61-2C405-AG, interchange CV612C405. Check your old unit's tag against those numbers before ordering. Ships Mon–Fri same day before 3pm EST. — Hubes
— Hubes
Vehicle fitment
Fits 2013–2015 Ford Escape. Replaces OEM # CV61-2C405-AG.
| Years | Makes | Models |
|---|---|---|
| 2013–2015 | Ford | Escape |
Please note: C520 Escape HCU, 2013-2015. One recycler extends this unit into 2016, but 2016 has its own service number (CV61-2C405-GA family) — verify by the part number on your unit label. Dealer programming expected on installation.
Is this your problem?
A quick diagnostic from the shop — see the symptoms before you buy, so you order the right part once.
Read the full transcript
Specifications
Part Identification
- OEM Part Number
CV61-2C405-AG- Brand
- Ford
- Also Replaces
CV612C405- Also searched as
CV612C405AG- Also Known As
- Anti-Lock Brake Module, ABS Pump, ABS Control Module, EBCM, HCU, Hydraulic Control Unit, ABS Hydraulic Unit
Condition & Testing
- Condition
- OEM Tested
Specifications
- Material
- Steel
- Connector Type
- Female
- Terminal Type
- Pin Plug
- Placement
- Front
Compliance
- Country of Origin
- United States





